5.4.3. Attenuator settings¶
In the Application settings Program -> Interface -> Attenuator
This tab is used to configure attenuator interface. An attenuator is a device used to reduce the power level of an optical signal by passing light through one or several optical filters. This tab becomes active when an “Attenuator” skin type is selected in “Program” tab.
Attenuator type group contains radio buttons which allow one to choose one- or two-wheel configuration of the attenuator. Depending on the choice here one or two Wheel groups become available. They should be filled with attenuator filters’ transparency values on the corresponding wheel, in order.